Intellitec 00-00131-000 BIC Battery Isolator Control

Intellitec 00-00131-000 BIC Battery Battery Isolator Controller has been designed specifically for vehicles that use dual battery systems and where starting power is crucial, such as utility vehicles, 4×4, ambulances and boats etc. FREE 2 to 3 Day SHIPPING LOWER 48 STATES The BIC Short for Batter Isolator Controller performs two important functions, firstly the system provides a reliable and efficient method of both charging and isolating dual batteries, secondly if the chassis battery voltage falls below 9.0V for half a second and the auxiliary battery is above 9.0V, both batteries are connected to boost starting. The BIC charging system operates by sensing the level of voltage on the chassis 12V system, when this voltage rises above 13.3V for 12 seconds, as happens when the engine is running normally, the BIC ECU will close the isolator relay, providing charging current to the auxiliary battery. When the ignition is switched off, the relay will open immediately. If the voltage on the main chassis system should drop below 12V for more than 2 seconds while the ignition is on, the relay will drop out, this scenario could happen if the alternator could not keep up with all the loads. When the chassis voltage rises above 13.3V again, the relay will again close in two seconds to try and charge the battery. The BIC system can also provide the driver with indicator lamps to indicate whether starting was as normal, from chassis battery or if it was a boost start from both batteries paralleled. Please Note The following about this product: Installation Requires 1 of the following Relays and 1 Wiring Harness: 100AMP Relay Isolator part #31-77900000100, 200AMP Relay part #586902B1, Relay part #120901, 7 Pin Wiring Harness part #31-1100200001 Tools required: Low current Test Light, Accurate Voltmeter We reccomend hiring a local Rv Technician to assit with the installation of this Part. We have listed All Parts Needed On Our Website. Specifications: Pull-in voltage: 13.3 +/- 0.3 volts Pull-in time: 15.0 +/- 4 seconds Drop-out voltage: 12.0 +/- 0.3 volts Drop-out time: 4 +/- 1 second Chassis battery: less than 9.0 +/- 0.3 volts Coach battery: more than 9.0 +/- 0.3 volts Pull-in time: approximately 0.5 seconds Indicator lamp current: 0.15 amps maximum Output current: 1.5 amps maximum Ambient temperature: -40?C to +85?C (-40?F to 185?F) Features: High quality at an affordable price Expertly made from premium materials Built to match your exact requirements Founded in 1994, Intellitec? has evolved from a small supplier of battery protection equipment to an internationally renowned manufacturer of electronic systems and other related products intended to solve your power problems. Intellitec?s product line consists of over 10,000 systems and parts used for power distribution, charging, switching, and controlling electrical systems in a wide variety of applications, including bus, truck, emergency service, leisure vehicles, and marine. Everything from batteries, battery chargers, monitors, and guards to inverters, isolation transformers, solar products, and much more, the company has the solution that meets your individual needs. Intellitec is proud to be ISO 9001 & 14001-2015 certified by ISOQAR and UKAS, and also holds accreditation by Vehicle Certification Agency for Conformity of Product (COP).